Julixing Instruments

Julixing Instruments

 
Julixing Instruments

Company News

Spring Operated Impact Test Hammer

Impact Test Requirements and Product Safety Standards

 

The ability of equipment to withstand mechanical impact, to ensure continued safety, or continuation of function, is a recognised requirement in most specifications.

 

Such requirements are specified in ISO, IEC & CEE standards as well as those of BSI, VDE and many other nationalities. In many cases the impact specified is by means of an internationally agreed Spring Operated Impact Hammer calibrated according to the requirements as specified in IEC 817: 1984 and BS 7003: 1988.

These standards have been revised and reissued as the following: BS EN 60068-2-63:1995 and IEC 68-2-63:1991 and laterally by BS EN 60068-2-75:1997 and BS EN 60068-2-75:2014

 

The Spring Operated Impact Test Hammer is made to the working drawings as described in the above specifications and is calibrated and certified to be within the required limits of impact energy. The construction consists of a moving hammer head having a hard polyamide hemispherical face, mounted in a cylindrical body. A knob is attached to the rear of the hammer shaft for the purpose of compressing the hammer spring and setting the striking mechanism. The mechanism is released by applying pressure to the front nose cone. Blows to the sample under test are applied by pushing the release nose slowly against the sample until the release mechanism operates, allowing the spring to propel the hammer against the sample.

 

Hammers can be supplied with pre-set values of energy from 0.2 J(Nm) to 1.0 J(Nm). Impact Energy is designated in SI units as Joules (J), although historically measured in Newton Metres (Nm). A very common value is, however, 0.5 J(Nm) ± 0.04 J(Nm), which is specified for the enclosures of most domestic electrical appliances and similar equipment. Standard testing industry energies include 0.2J, 0.35J, 0.5J, 0.7J & 1.0 Joule. Each hammer is supplied complete with a UKAS certificate of calibration and contained in a wooden instrument case.


    Standard:       IEC 61032 IEC 60061 IEC 60335 IEC 60529 IEC 60068 IEC 60695 VDE 0620 UL AS/NZS3112
    TAG:
Test Probe Go No Go Gauge Spring Impact Hammer Integrating Sphere Finger Probe Test Test Probe Pin Probe Weighing Sensor
 
Glow Wire Tester Impact Test Hammer Go Gauge UL Test Finger Probe Hipot Tester Test Probe Needle Impact Testing Machine
  Español   Español Svenska   Svenska لعربية   لعربية русский   русский Português   Português 中国  中国 Polski   Polski Română   Română Dansk   Dansk suomi   suomi
  Français   Français hrvatski   hrvatski Ελληνικά   Ελληνικά Nederlands   Nederlands česky   česky Deutsch   Deutsch 日本の   日本の Italia   Italia български   български นไทย   นไทย
test probe