Julixing Instruments

Julixing Instruments

 
Julixing Instruments

Company News

Manuals of Test finger nail

Test finger nail Non-detachable parts that protect against access to live parts, moisture or contact with moving parts shall be fixed in a reliable manner and withstand the mechanical stress occurring during normal use. Snap-in devices used for fixing such parts shall have an obvious locked position. The fixing properties of snap-in devices used in parts that are likely to be removed during installation or servicing shall be reliable.

Compliance is checked by the following tests.

 

Parts that are likely to be removed during installation or servicing are disassembled and assembled 10 times before the test is carried out.

 

NOTE Servicing includes replacement of the supply cord, except in appliances with a Type Z attachment.

 

The test is carried out at room temperature.

The test is applied to all parts that are likely to be detachable whether or not they are fixed by screws, rivets or similar parts.

 

A force is applied without jerks for 10 s in the most unfavourable direction to parts likely to be weak. The force is as follows:

push force, 50 N;

pull force:

 

if the shape of the part is such that the fingertips cannot easily slip off, 50 N;

if the projection of the part that is gripped is less than 10 mm in the direction of removal, 30 N.

 

The push force is applied by test probe 11 of IEC 61032.

iec60335

The pull force is applied by a suitable means, such as a suction cup, so that the test results are not affected. While the force is being applied, the test fingernail of Figure is inserted in any aperture or joint with a force of 10 N. The fingernail is then slid sideways with a force of 10 N but is not twisted or used as a lever.

 

 

If the shape of the part is such that an axial pull is unlikely, the pull force is not applied but the test fingernail is inserted in any aperture or joint with a force of 10 N and is then pulled for 10 s by means of the loop with a force of 30 N in the direction of removal.

 

If the part is likely to be twisted, the following torque is applied at the same time as the pull or push force:

2 Nm, for major dimensions up to 50 mm;

4 Nm, for major dimensions over 50 mm.

Manuals of Test finger nail

 

This torque is also applied when the test fingernail is pulled by means of the loop.

 

If the projection of the part which is gripped is less than 10 mm, the torque is reduced by 50 %.

 

Parts shall remain in the locked position and not become detached.

    Standard:       IEC 61032 IEC 60061 IEC 60335 IEC 60529 IEC 60068 IEC 60695 VDE 0620 UL AS/NZS3112
    TAG:
Test Probe Go No Go Gauge Spring Impact Hammer Integrating Sphere Finger Probe Test Test Probe Pin Probe Weighing Sensor
 
Glow Wire Tester Impact Test Hammer Go Gauge UL Test Finger Probe Hipot Tester Test Probe Needle Impact Testing Machine
  Español   Español Svenska   Svenska لعربية   لعربية русский   русский Português   Português 中国  中国 Polski   Polski Română   Română Dansk   Dansk suomi   suomi
  Français   Français hrvatski   hrvatski Ελληνικά   Ελληνικά Nederlands   Nederlands česky   česky Deutsch   Deutsch 日本の   日本の Italia   Italia български   български นไทย   นไทย
test probe