Julixing Instruments

Julixing Instruments

 
Julixing Instruments

Company News

IPX5/IPX6 Water Jet Nozzle Test Method

 IEC60529 Spray water test Nozzle, IPX56 water Jet Nozzle

Test Set consists of a jet handle that is equipped with a pressure gauge and an easy-to-adjust flow valve.

The interchangeable nozzles assemble easily to the jet handle. The nozzles are made from stainless steel.


Item

IPX5

IPX6

Water supply

Water flow rate > 12.5L/min±5% clean water witho ut inclusion.
It can be achieved by the stainless steel water tank and pressurized equipment.

Water flow rate > 100L/min±5% clean water witho ut inclusion.
It can be achieved by the stainless steel water tank and pressurized equipment.

The nozzle diameter

6.3 mm

12.5 mm

Water flow

12.5±0.625L/min, Flow meter is adjustable.

100±0.625L/min, Flow meter is adjustable.

Testing time

Not less than 1min/(not less than 3 mins)

Environment requirements

Dedicated IP waterproof test room whose width is more than 3m, With good function of inflow and drainage. Wall installation.

The distance from jet nozzle to enclosure

2.5~3m

Pressure Gauge

0 - 2.5 bar ( 0 - 0.25 MPa )

Reference standards

IEC60529,IEC60598-1,IEC60335-1,IEC60745-1

Nozzle Material

Stainless Steel

Include

Pressure gauge, Stainless steel nozzle IPX5 and IPX6, Valve for water flow regulation and shut off, Hose connector.




1.IPX5: spray holes of 6.3 mm, can meet the 12.5 L/min (100 L/newspapers) + 0.625 L/min;

 

Test method: the center of water from the nozzle diameter at 2.5 m for 40 mm circle, specimen surface water every square metre shell time about 1 min, test specimen at least 3 min, The nozzle surface distance from shell specimen should be 2.5 ~ 3 m;

 


 

2.IPX6: spray holes of 12.5 mm, can meet the 100 L/min (6000 L/newspapers) + 5 L/min;


Test method: the center of water from the nozzle diameter at 2.5 m for 120 mm circle, specimen surface water every square metre shell time about 1 min, Test time: at least 3 min, The nozzle distance: the nozzle surface distance from shell specimen should be 2.5 ~ 3 m;

    Standard:       IEC 61032 IEC 60061 IEC 60335 IEC 60529 IEC 60068 IEC 60695 VDE 0620 UL AS/NZS3112
    TAG:
Test Probe Go No Go Gauge Spring Impact Hammer Integrating Sphere Finger Probe Test Test Probe Pin Probe Weighing Sensor
 
Glow Wire Tester Impact Test Hammer Go Gauge UL Test Finger Probe Hipot Tester Test Probe Needle Impact Testing Machine
  Español   Español Svenska   Svenska لعربية   لعربية русский   русский Português   Português 中国  中国 Polski   Polski Română   Română Dansk   Dansk suomi   suomi
  Français   Français hrvatski   hrvatski Ελληνικά   Ελληνικά Nederlands   Nederlands česky   česky Deutsch   Deutsch 日本の   日本の Italia   Italia български   български นไทย   นไทย
test probe